Alcoscan ALP-1 Breathalyzer with replaceable fuel cell sensor (Mobile thermal printer compatible)
Alcoscan ALP-1 Breathalyzer with replaceable fuel cell sensor (Mobile thermal printer compatible)
Complies with U.S. Coast Guard requirements for the drug and alcohol testing regulations in Title 46 Code of Federal Regulations (CFR) Parts 4 and 16.
No Recalibration is needed. Just purchase a Pre-Calibrated Sensor and replace worn sensor.
- Fuel cell sensor technology
- Prints instantly on wireless mobile thermal printer
- Stores 500 sets of results with SD card
- Able to perform both active and passive test
- Level of Accuracy suitable for
- Law Enforcement, high end Workplace Testing, Prisons, Hospitals
The APL-1 is a high-end breath alcohol tester in Alcoscan line of products. It uses a high-quality fuel cell sensor to ensure highly accurate readings. It produces highly consistent readings when users take readings consecutively. This distinguishes itself with the below features-
Complies with USCG regulations- The regulations in 46 CFR Parts 4 and 16 were developed and first promulgated in 1988 as part of the Department of Transportation (DOT) program to address drug and alcohol use in the U.S. transportation system. The ALP-1 breathalyzer meets the requirement by the US Coast Guard.
± 0.005%BAC at 0.100%BAC When a person's actual breath alcohol concentration is 0.100%, the ALP-1 will always produce a result between 0.105% to 0.095%.
3 types of testing modes:
-
Standard Mode:
Numerical test results (in %BAC, mg/l, %, etc).
Requires a standard mouthpiece for each user. -
Passive Mode:
Designed for quick screening or mass testing.
The result is displayed “P” (PASS) or “F” (FAIL). Requires an open mouthpiece.
-
Manual Mode:
Analyses the breath sample by pushing a button in either standard or passive mode.
- Fuel Cell sensor
- No Recalibration- Pre-Calibrated Sensor Modules Available
- Mobile Wireless printing
- Onboard memory
- 3 steps audible warning when breath alcohol concentration exceeds pre-configured levels
- Sensors last at least 1,000 samples before a replacement is needed *
*The Manufacturer recommends calibration after every 12 months*
*When used according to the guidelines set out in the manual.
Content:
- ALP-1 Breathalyzer Unit (fitted with a pre-calibrated sensor)
- 5 x Free Replaceable and Reusable Mouthpieces
- 1 x Reuseable open mouthpiece for testing in Fast Mode
- Software and cable to transfer results to a PC
- User Manual
- Soft Carrying Pouch and Strap
- Plastic case
- 2 x AA Batteries
- Printer to be purchased separately
- Note that additional replaceable Sensor is sold separately and not part of the package.